Filter
Top Products
15
1 Hold down Stop/Cancel and then press the DOUBLE QUANTITY pad.
press both for 2 seconds.
2 Select desired program code by using NUMBER pads.
3 Press NUMBER pads to set the magnification factor within the range from
1.00 to 9.99.
➢ Default factor is 1.65 preset from the manufacturer for increasing the
cooking time.
For example, if you are cooking for 1 minute 30 seconds (1:30), and
use the default factor(1.65), your new cooking time will be 2 minutes
29 seconds (2:29).
Make sure that you set a correct factor between 1.00 and 9.99 for
each memory code number.
4 Press Start pad.
5 Press Stop/Cancel pad to exit the programming mode.
➢ Though you can successfully set a double quantity factor that
exceeds the maximum time allowed for each power level, the oven
will not exceed the maximum time when operated.
Double Quantity Pad Programming
Feature Key Entry Display Remark
1 Hold down Stop/Cancel and then Hold down for 2 sec.
Double Quantity pad.
2 Select desired memory If you press pad 1, default value shows
number in the display window after 1sec.
3 Input desired factor value 1.00 ~ 9.99 available
by pressing NUMBER pad. (Change the factor if required.)
4 Start/20sec.+ Reach completion
If you want to continue to edit new memory number,
follow the above procedures (2~4)
5 Stop/Cancel (Mode cancel) This exits the editing mode.
Double Quantity
Factor Edit
CM1229B-2 8/8/00 11:50 AM Page 15