Filter
Top Products
58_ Troubleshooting
PROBLEM POSSIBLE CAUSE SOLUTION
Areas of
discoloration on the
cooktop
Food spillover was not cleaned. Refer to the section on care and cleaning •
of the glass cooktop on page 54.
The surface is hot and the model
features a light-colored cooktop.
This is normal. The surface may appear •
discolored when it is hot. This is temporary
and will disappear as the glass cools.
The surface unit
frequently cycles on
and off.
This is normal. The element will cycle on and off to •
maintain the heat setting.
The oven will not
turn on.
The range is not completely
plugged into the electrical outlet.
Make sure the electrical plug is inserted •
into a live, properly grounded outlet.
A fuse in your home may be blown
or the circuit breaker tripped.
Replace the fuse or reset the circuit •
breaker.
The oven controls have been set
improperly.
See the chapter on operating the oven.•
The oven is too hot. Allow the oven to cool.•
The appliance will
not turn on.
The appliance is not completely
plugged into the electrical outlet or
a fuse in your home may be blown
or the circuit breaker tripped.
Make sure the power cord is plugged into •
a live, properly grounded outlet. Check the
fuse and circuit breakers.
Incomplete service wiring. Call for service.•
Power outage. Check to see if the house lights will turn •
on. If required, call your local electric
company for service.
The oven light will
not turn on.
The light bulb is loose or defective. Tighten or replace the bulb.•
The switch operating light is
broken.
Call for service.•
Oven smokes
excessively during
broiling.
The control has not been set
properly.
Refer to the section on setting oven •
controls.
Make sure the oven door is opened to the •
broil stop position.
The meat has been placed too
close to the element.
Reposition the rack to provide proper •
clearance between the meat and the
element. Preheat the broil element for
searing.
The meat has not been properly
prepared.
Remove the excess fat from the meat. Cut •
away fatty edges that may curl, leaving the
lean intact.
The insert on the broiler pan has
been positioned upside down,
preventing the grease from
draining.
Position the insert on the pan so that •
the ribs are up and the slots are down,
allowing the grease to drip into the pan.
Grease has built up on oven
surfaces.
Regular cleaning is necessary when •
broiling frequently.
Food does not bake
or roast properly.
The oven controls have not been
set correctly.
See the chapter on operating the oven.•
The oven rack has been positioned
incorrectly or is not level.
See the section on using the oven racks •
on page 52.
Incorrect cookware or cookware of
improper size being used.
The oven sensor needs to be
adjusted.
See the section on adjusting the •
thermostat on page 46.
FE-R700_XAC DG68-00294A.indb 58 2010-02-18 �� 11:36:21