Filter
Top Products
06 TROUBLESHOOTING
Troubleshooting _59
PROBLEM POSSIBLE CAUSE SOLUTION
Food does not broil
properly.
The oven controls have been set
incorrectly.
Press the • BROIL pad.
The rack has not been properly
positioned.
See the broiling guide on page 41.•
Cookware not suited for broiling. Use suitable cookware.•
Aluminum foil used on the broiling
pan and grid has not been fitted
properly and slit as recommended.
See the section on broiling on page 42.•
In some areas the power (voltage)
may be low.
Preheat the broil element for 10 minutes.•
See the broiling guide on page 41.•
The oven
temperature is too
hot or too cold.
The oven sensor needs to be
adjusted.
See the section on adjusting the •
thermostat on page 46.
Scratches or
abrasions on
cooktop surface
The cooktop is being cleaned
improperly.
Scratches are not removable. Tiny •
scratches will become less visible in time
as a result of cleaning.
Cookware with rough bottoms
were used on the cooktop or
there were coarse particles (eg.
salt or sand) present between the
cookware and the surface of the
cooktop.
To avoid scratches, use the recommended •
cleaning procedures. Make sure bottoms
of cookware are clean before use, and use
cookware with smooth bottoms.
Cookware has been slid across the
cooktop surface.
Brown streaks or
specks
Boilovers have been cooked onto
the surface.
Use the blade scraper to remove soil.•
See the section on care and cleaning of •
the glass cooktop on page 54.
Areas of
discoloration with
metallic sheen
Mineral deposits from water and
food have been left on the surface
of the cooktop.
Remove using a ceramic-glass cooktop •
cleaning cream.
Use cookware with clean, dry bottoms.•
The oven will not
self-clean.
The oven temperature is too high
to set a self-clean operation.
Allow the range to cool and reset the •
controls.
The oven controls have been set
incorrectly.
See the section on self-cleaning on page •
47.
A self-cleaning cycle cannot be started if the oven lockout feature has been
activated or if a radiant surface element is on.
“Crackling” or
“popping” sound
This is the sound of the metal
heating and cooling during
both the cooking and cleaning
functions.
This is normal.•
Excessive smoking
during a self-
cleaning cycle
There is excessive soiling in the
oven.
Press the • CLEAR/OFF pad. Open the
windows to rid the room of smoke. Wait
until the self-cleaning cycle is cancelled.
Wipe up the excessive soil and reset the
oven for self-cleaning.
The oven door will
not open after a
self-cleaning cycle.
The oven is too hot. Allow the oven to cool.•
FE-R700_XAC DG68-00294A.indb 59 2010-02-18 �� 11:36:21