Filter
Top Products
operating _17
02 OPERATING
( 4 ) Energy Saver
(Hold 3 sec for °C↔°F)
Touching this button turns Energy
Saver mode on and off. When you
turn Energy Saver on, the Energy
Saver icon lights.
Turn Energy Saver off and the icon
goes off. The Energy Saver function
is set to “ON” in the factory.
If condensation or water drops
appear on the doors, turn the Energy
Saver mode off.
Touch and hold this button for 3
seconds to switch the temperature
units between °C and °F.
( 5 ) Fridge (Hold 3sec for Power Cool)
Touch this button to set the fridge
to your desired temperature. You
can set the temperature between
34 °F and 44 °F (between 1 °C and
7 °C). Touch and hold this button
for 3 seconds to decrease the time
needed to cool products in the
Refrigerator. This can be helpful if you
need to quickly cool easily spoiled
items or if the temperature in the
fridge has warmed dramatically (For
example, if the door was left open).
( 6 ) Lighting (Hold 3 sec for child lock)
Touching this button sets the
Dispenser LED lamp (under the
display) to continuous mode so that
it stays on continuously.
The button also lights up. If you want
the Dispenser lamp to come on only
when some one uses the dispenser,
touch this button to turn the
continuous mode off. Also, pressing
this button for 3 seconds turns on
Child Lock which locks the display
panel and dispenser buttons so the
buttons can not be used. The Child
Lock icon lights up to indicate you’ve
activated the Child Lock function.
Press 3 seconds to unlock.
( 7 ) Ice Type
Press the Ice Type button to change
the ice type. Each time you press
the Ice Type button, the cubed and
crushed ice modes alternate and the
Cubed or Crushed ice icon lights up,
indicating your selection.
If you don’t need ice, turn the function
off to save on water and energy
consumption (See Ice Off below).
( 8 ) Ice Off (Hold 3 sec)
Press the Ice Off button for 3
seconds until the Ice Off Indicator
( ) illuminates.
( 9 ) Filter
Water filter usage
This icon will light up when you
need to change the filter. After you
use about 300 gallons of water, the
filter indicator lights up (in about 6
months). After you install the new
water filter, reset the filter indicator
by pressing the Alarm/hold 3 sec for
Filter Reset button.
• If water is not dispensing or
dispensing slowly, you need to
replace the water filter because
the water filter is clogged.
• Some areas have large amounts
of lime in their water, which
causes the water filter to clog
more quickly.
Cooling Off Mode
- North American (US, Canada) Models Only ;
Cooling Off mode (also called Shop
mode), is designed for use by retailers when they
are displaying refrigerators on the shop floor. In
Cooling Off mode, the refrigerator’s fan motor and
lights work normally, but the compressors do not
run, and the refrigerator and freezer do not get
cold. To start Cooling Off mode, touch and hold
the CoolSelect button and the Freezer button
for 5 seconds during normal operation. The
refrigerator chime sounds and the temperature
display flashes “OFF”.
To cancel Cooling Off mode, touch and hold the
CoolSelect and the Freezer buttons again for 5
seconds.
DA68-02918A-02.indb 17 13. 12. 2. �� 5:05