Filter
Top Products
01 SETTING UP
5. Position the top table (
9
) in place. Insert the 3
screws into the top table, and tighten with a philips
screw driver (+). Open the door, reinsert the cap top
table (
10
) and close the doors.
5. Position the top table (
9
) in place. Insert and tighten
the 3 screws into the top table with a philips screw
driver(+). After door opened, reinsert the cap top table
(
10
) and close the doors.
REATTACHING THE REFRIGERATOR DOORS
4. Connect the connector (
7
) on the left side door and
two connectors (
8
) on the both side of doors.
When reattaching the top table, make sure that the
wires are not pressed or damaged by the hinge cover.
After assembling, close the door and check to see
whether the door has gaps between gaskets or is
tilted. If they are, please refer to “Adjusting the level” on
page 15.
10
9
8
7
8
Setting Up _13