Filter
Top Products
PRECAUTIONS FOR SAFE OPERATION
o
o
o
o
e
~WARNING
Do
not use the unit outdoors. Current
leakage or electric
shOck
may result
if
the
unit
is exposed to rainwater.
Only qualified engineers or service personnel
should
install the unit. The installation
by
unqualified personnel may cause gas or liquid
leakage, electric shock or fire.
Be
sure
to
install the unit
on
a sturdy floor.
If
the floor
is
not strong enough
or
the installation
site is not adequate, this may result
in
injury
from the unit
falling or tipping over.
Never
install the unit
in
a humid place or a
place where it is
likely
to
be
splashed
by
water.
Deterioration of the insulation may result which
could cause current leakage
or
electric shock.
Never
install the unit
in
a flammable or volatile
location. This may cause explosion
or
fire.
Never
install the unit where acid or corrosive
gases are present as current leakage or
electric shock may result due to corrosion.
Make sure a dedicated power source
is
used
as indicated
on
the
rating label attached
to
the
unit.
Make sure to remove dust from the power
supply
plug
before inserting
in
a power source.
A dusty plug or improper insertion may pose a
hazard.
Use a power supply outlet with ground (earth)
to prevent electric shock.
If the power supply
outlet
is
not grounded, it will
be
necessary
to
install a ground
by
qualified engineers.
2
o
o
Never ground the unit through a gas pipe,
water
main,
telephone line or lightening
rod.
Such grounding may cause electric shock
in
the case of
an
incomplete circuit.
Do
not insert metal objects such as a
pin
or a
wire into any vent, gap or any outlet for inner
air circulation. This may cause electric shock
or injury
by
accidental contact with moving
parts.
Never store volatile or flammable substances
in
this unit. This may cause explosion or fire.
Never store corrosive substances in this unit.
This may
lead
to
damage to the inner
components or electric parts.
Make sure to use this unit
in
safe area when
treating the poison, harmful or radiate articles.
Improper use may cause
bad
effect
on
your
health or environment.
Make sure
to
prepare a safety check sheet
when
you
request
any
repair or maintenance
fO!
the
safety of service personnel.
Always disconnect the power supply
to
the unit
prior
to
any repair or maintenance of the unit
in
order
to
prevent electric shock or injury.
Ensure
you
do
not inhale or consume
medication or aerosols from around the unit at
the time of maintenance. These may
be
harmful
to
your health.
Never splash water directly onto the unit as this
may cause electric shock or short circuit.