Filter
Top Products
9
REFRIGERATOR COMPONENTS
1. Door:
Sliding type. The recessed portion on the rail enables the self-closing of the door. The glass is pair
construction.
2. Control panel:
Panel can be opened when upper right corner of the lower part cover is pushed. Refer to page 10.
3. Space for automatic temperature recorder:
An automatic temperature recorder (optional accessory) can be mounted here. See page 13.
4. Access port:
This port allows temperature measurement cables to enter the chamber from outside.
5. Handle:
Always hold the middle of the handle indicated by a label when opening/closing the door.
6. Lock:
To lock, turn clockwise to 90
o
with a key, push the key and turn counterclockwise to 90
o
with the key
pushed. The door can be securely locked.
7. Fluorescent lamp:
20 W white light in MPR-513 and MPR-513R. 40 W white light in MPR-1013 and MPR-1013R. For the
replacement, refer to page 22.
8. Light switch:
This switch is used for turning the fluorescent lamp off and on.
9. Air intake vent (in the chamber):
Do not block this vent. If this vent is blocked, temperature regulation will become unstable.
10. Air exhaust vent:
Do not block this vent. If this vent is blocked, temperature regulation will become unstable. Do not place
stored items in the path of the cold air.
11. Drawer (Right side of MPR-1013R and MPR-513R):
Items to be stored in the chamber must be placed on the drawers. To pull out the drawer, take out the
drawer with pushing the button on the bottom of the drawer. The maximum storage weight for each
drawer is 20 kg.
12. Shelf:
Items to be stored in the chamber must be placed on the shelves. The maximum storage weight for each
shelf is 50 kg. (For MPR-513R, allowable weight is 20 kg.) Do not put stored items directly onto the
interior floor of the chamber.
13. Leveling feet:
Adjust the height of the leveling feet by turning the screw bolts until the unit is level.
14. Door switch:
The door check lamp is lit when the door is open.
15. Unit cover:
The refrigerating units are mounted inside the cover. Remove this cover at the time of cleaning of
evaporating tray and filer (filter is attached in MPR-1013 and MPR-1013R only).
16. Evaporating tray:
Defrost water from the evaporator accumulates on the tray and evaporates into the atmosphere. See
page 21 for cleaning.
17. Circuit breaker:
Switch ON this breaker before the unit starts to run. When the operation of the unit is stopped by this
breaker, contact a dealer or a service station after disconnected the power supply plug.