Filter
Top Products
Use and Operation
Once started, the ice machine will automatically
make ice until the curtain is held open by the ice at
the top of the pile. The typical ice level when the
machine is off will be several inches below the door
sill. When ice level drops from use or meltage, the
ice machine will resume making ice. If a small
cluster of ice is holding the curtain open, open the
curtain slightly to release it. The machine should
resume making ice in a few minutes.
Tip: Scoop the ice to the front and back of the bin
to maximize storage.
There are four indicator lights under the bin that
provide information on the condition of the
machine.
Indicator Lights:
•
Power
•
Status
•
Water
•
De-scale & Sanitize
If the Water light is on, the machine has sensed a
lack of water. Check the water supply to the
machine. The water could have been shut off or the
water filter cartridges might need to be changed.
If the De-Scale light is on, the machine has
determined that it needs to be cleaned. Contact an
authorized Scotsman service agent and have the
machine cleaned, de-scaled and sanitized.
May 2008
Page 12
CU1526, CU2026, CU3030
User Manual
Note: A Component Indicator Light switches ON to
indicate that the component is operating.
Note: There are two Curtain Switch lights, SW1 and
SW2. These single plate models have one curtain
switch light on all the time, as a curtain switch light
is ON when a curtain is either open or not present.
Indicator Lights & Their Meanings
Power Status Water
De-Scale &
Sanitize
Steady Green Normal Normal - -
Blinking Green
Self Test
Failure
Switching on or off - -
Yellow -
Diagnostic shut down, or, if making
ice, temperature sensor failure
Lack of
water
-
Blinking
Yellow
-- -
Time to de-scale
and sanitize
Light Off - - - In Cleaning mode
All blinking Unit remotely shut off and locked out - check with leasing company.
Ice Level When Bin Is Full