Filter
Top Products
Control Switches
There is a front on and off switch, located in the top
center of the louvers. Switching this switch Off will
immediately stop the machine. Switching it back on
will cause the machine to restart in a timed harvest
cycle. When that cycle is complete, normal ice
making will resume.
The controller (located inside the cabinet) also has
on and off switches, which can also switch the
machine on and off, but their operation is different:
To switch the machine OFF, push and release the
Off button. The machine will shut off at the end of
the next cycle. To shut the machine off
immediately, push and hold the Off button for 3
seconds.
To switch the machine ON, push and release the
On button. The machine will go through a start up
process and then resume ice making.
Ice
The cuber drops ice in large sections. That ice will
break up into random parts as it falls into the bin,
but some large sections may remain on top of the
ice in the bin. When removing ice, tap the groups of
ice with an ice scoop to separate them into smaller
units.
Using the ice will help to level it out and allow the
machine to fill it to its maximum level.
Heat
Air cooled models will generate heat when in
operation. That heat is discharged out the front of
the cabinet.
Noise
The ice machine will make noise when it is in ice
making mode. The compressor, fan motor(s) if air
cooled and water pump all produce some sound. It
is also normal to hear some cracking just before
the harvest cycle begins. In addition, during the
harvest cycle the harvest assist solenoid will click
twice as it pushes the ice out and returns to its
normal position. The ice harvests as a unit or slab,
which makes some noise when it impacts the bin.
These noises are all normal for this machine.
May 2008
Page 13
CU1526, CU2026, CU3030
User Manual