Filter
Top Products
FOR THE ELECTRICIAN
CONFORM TO ALL APPLICABLE CODES
The electrical power to the unit is
supplied through the junction box at the
rear of the machine.
Check the nameplate (located on the
back panel) for the voltage
requirements, and for the minimum
circuit ampacity. The machine requires
a solid chassis to earth ground wire.
The ice maker should be connected to
its own electrical circuit so it would be
individually fused. Voltage variation
must remain within design limitations,
even under starting conditions.
All external wiring must conform to
national, state, and local electrical
codes. The use of a licensed
electrician is required to perform the
electrical installation.
MDT5N25 & MDT5N40
July 2003
Page 7
JUNCTION
BOX
INDIVIDUAL CIRCUIT
FOR ICE DISPENSER