Filter
Top Products
REMOVABLE KNOBS
All control knobs may be removed for easy cleaning by
pulling the knob straight off the stem. Be sure that the
knob is in the OFF position before removal.
Hint: Slip a thin cloth (such as a handkerchief) or a piece
of string under and around the knob edge and pull up.
Caution: Read these instructions carefully be-
fore replacing the knobs. Replacing the knobs
improperly will damage the knobs and the spring
clip on the stems, if this happens, the knobs will
fit loosely,
To replace the knob:
1. The knob stem has a groove tn each side. The
groove on one side has a spring clip. The other
groove is clear (see illustration).
2_
3.
Check the inside of the knob and find the molded rib.
Replace the knob by fitting the molded rib Inside the
knob Into the clear groove on the stem.
MOLDED
RIB
CLEAR GROOVE
IN STEM
Note: Be sure to replace knobs on correct stems from
which they came.
ANTSoT IP DEVICE
if your range is removed for cleaning,
servicing or any reason, be sure anti.
tip device is re.engaged properly
when the range is replaced. Fa_llure
to take this precaution could result in
tipping of the range and cause injury.
When replacing the range:
1. Hook the loose end of the chain onto the bracket by
slipping the nearest link of the chain into the slot in
the bracket, making sure the chain is pulled as tight
as possible and that there is no excess slack in the
chain after chain is attached to the bracket.
2_
. Excess slack in the chain could allow the range to
tip over.
Slide the range all the way back into the counter.
Oncethe range is pushed back tn place, there will be
a small amount of slack in the chain. This is normal.
NOTE: To insure the device Is installed and re-en-
gaged properly, carefully try to tip the range
forward. The device should secure the range
and not allow it to tip.
BRACKET...
OPTIONAL
LOCATION
CHAIN "_
BRACKET/
FACTORY
LOCATION
e
iRD
(Electric model shown;
Opposite side used for Gas models)
18 NEMNT66