Filter
Top Products
LIFT-UP COOKTOP
The cooktop can be raised or removed so the area
underneath can be cleaned.
To raise cooktop:
1. Remove the burner grates.
2. Grasp the cooktop and lilt up.
To remove cooktop:
1. Remove the burner grates.
2. Grasp the cooktop and lilt the front a little.
3. Grasping the cooktop at the sides, hold It nearly flat
while you lilt It up and off.
Porcelain enamel can chip. Handle porcelain enameled
cooktops carefully.
HOLD COOKTOP FLAT TO REMOVE
SUPPORT ROD
REMOVABLE COOKTOP BURNERS
The cooktop burners on your range may be removed for
cleaning. Be sure all cooktop knobs are turned to
OFF and burners are cool, then remove or raise
the cooktop.
If shipping screws were not removed from the burner
when the range was Installed, do so now (sea your
Installation section for Instructions).
To replace bumers:
1. Slip the air shutter over the gas valve orifice (Fig. A).
2. Lower the burner assembly and hook the tab In the
slots In the burner support (Fig. A).
3. Be sure both tabsare Inthelr slots, thet the burner sits
level and stralgnt and that the flash tube forms a
straight line from the Igniter to the burner (Fig. B).
BURNER GAS VALVE
SUPPORT ORIFICE
IGNITER BRACKET
DO NOT REMOVE SCREWS
FROM IGNITER BRACKET
To remove burners:
1. Grasp the burner head and tilt it to the right to release
the two tabs from the burner support (A In Fig. A).
2. Lift the end of the burner assembly, then pull away
from the front of the range to free the air shutter from
thegas valveorlfice (Fig. B). If theyare clogged, use
a wire or needle to clear them.
See the Cleaning Chart.
Be careful not to disturb the air shutter setting
while cleaning. If you need to readjust the air shutter,
see the Installation Section.
TAB AIR
SHUTI'ER
BURNER FLASH
PORTS TUBE
UGHTER
PORTS
BURNER
SUPPORT
fig. A
Fig. B
PILOT OR
IGNITER
13 NGMNT28-1