Filter
Top Products
Electronic Alert & Diagnostic System
LZIE!
p_:POWER
dE DEFROST
_ FRBS_
El !CEMAKER
WATER Kenmore
(_ Red signal light flashes to tell you when either door is
open,
(_) Signal light tells you that the Door Alarm beeper has
been set to sound after either door has been open 30
seconds_
(_) Red signal light tells you when freezer foodkeeping
temperature is above normal.
(_ Lighted word normal indicates that no
failur e has been detected by the diagnostic system
(_) Flashing diagnostic codes in the display
warn you when:
B power has been interrupted
[]defrost system has failed
11_ frozen foods should be checke&
[ icemaker may not be operating properly
What these codes mean-and what to do when they
appear-is summarized on the inside of the freezer
compartment door and explained more thoroughly on
the following pages
(_ System Check pod puts a review of the electronic
diagnosis of four coded functions at your fingertip
and also allows you to erase codes from display,
(_ Electronic control allows you to select ice cubes,
crushed ice or chilled water and signal light confirms
your choice
CUBED,cE] DOOR 1
l.woN!on:;
t
When your refrigerator isfirst plugged in...
All panel lights come on for five seconds, a beep sounds,
and lights go off except as follows:
• PFflashes inthe display Touch SYSTEM CHECK-RESET
pad to erase it
• Word NORMAL glows
• Red W'ARM TEMPERATURElight glows if freezer
compartment temperature is higher than normal It goes
off when proper foodkeeping temperature isreached
oDoor alarm beeper isactivated and light on DOOR
ALARM pad glows
" CRUSHED ice selection light glows,
Red DOOR OPEN light flashes ifeither door is open,
goes out when doors are shut.
° Night light in water-and-ice dispenser is off,