Filter
Top Products
Electronic Alert & Diagnostic System (continued)
The Electronic Alert and Diagnostic System
alerts you when something starts to go wrong
tf a system code appears on the display,
something needs special attention_ To get your
attention, the display code flashes until you erase it
The first 6 flashes are accompanied by beeps_
If more than one coded function requires attention
at the same time, the one with the highest priority will
be displayed firsL
Pressing the SYSTEM CHECK-RESETpad wiI! evaluate all
other coded functions If the NORMAL display islit
during the displaying of o code, that function isoperating
properly
Pressing theSYSTEM CHECK-RESETpad will erase
two codes immediately-PF, and CI The DE and
FF codes can only be erased by touching the
SYSTEM CHECK-RESET pad after the condition
that caused the code to flash has been corrected.
This flashing code tells you the
power to the refrigerator has
been interrupted for more than
2 seconds Check the condition
of food in both the Freshfood and
freezer compartments Touch
SYSTEM CHECK-RESETpad to
erase code,.
There is no fault with the refrigerator when
PFcode flashes,
This flashing code tells you
something's wrong with the defrost
system- keep doors closed to
retain cold and call for servicer
Code flashes until problem is
corrected
This flashing code tells you
to check your frozen food.
Has any of itstarted to thaw?
A package may be holding the
freezer compartment door open
Don't open the door more often
than absolutely necessary while
thiscode isdisplayed Touching the
SYSTEM CHECK-RESETpod after the freezer
compartment temperature has returned to norma{ wil!
erase the code
This flashing code tells you to
check the automatic icemaker.
Ice clumps in the storage bin may
have stalled the icemaker Follow
corrective measures described on
page 9. If water supply to the
icemaker is not connected or not
turned on, make sure manual
icemaker switch isin the STOP position Code stops
flashing when problem iscorrected or SYSTEM CHECK-
RESETpad istouched