Filter
Top Products
12
are corrected correspondingly. Due to the missing sen-
sor, individual rechargeable battery cells will not be
identified as accupacks.
y The monitoring of the accupack temperature during
charging in the L 2015 charger.
y The prevention of improper charging of inserted pri-
mary cells (batteries). Due to the missing sensor, indi-
vidual rechargeable battery cells will also not be
charged in the L 2015 charger.
Connecting units to the audio output
You can connect a PA system or a recording unit (e.g. video
camera) to the receiver.
̈ Connect one of the supplied line output cables to the
reco rding unit.
̈ Connect the 3.5 mm jack plug to the audio output (AF
OUT) ¹.
̈ Lock the 3.5 mm jack plug by screwing down the
coupling ring.
̈ Via the operating menu, adapt the level of the audio
output (AF OUT) to the input sensitivity of the
connected unit (see “Adjusting the audio output level”
on page 23).
Mounting the receiver to a camera
Use the supplied camera kit to mount the receiver to the
camera’s flash mount.
The camera kit consits of:
y 1 perforated plate ¹
y 1 flash mount adapter Ƹ
y 2 square nuts ƹ
̈ Determine where on the perforated plate the flash
mount adapter Ƹ will need to be fastened so that the
receiver can best be attached to the camera.
̈ At this position, place a square nut ƹ under the
perforated plate ¹.
¹