Filter
Top Products
22
̈ Use the ̆/̄ rocker button to select the desired
receiving frequency. Your selection becomes effective
immediately. Receiving frequencies are tunable in
25-kHz steps within a switching bandwidth of 36 MHz
max. For intermodulation-free frequencies, please refer
to the enclosed frequency table.
Scanning the channel banks for free
channels –
SCAN
Before putting one or several ew 500 G2 transmission links
into operation, you should scan the channel banks for free
channels.
Starting the scan and storing the scan result
̈ Before starting the scan, switch all transmitters of your
system off, since channels used by switched-on
transmitters will not be displayed as “free channels”.
̈ Select the channel bank that you want to scan for free
channels (see “Switching between channel banks” on
page 21).
̈ Select the “SCAN” menu.
̈ Select “START” and confirm your selection by pressing
the SET button. After the scan is completed, the number
of free channels is displayed. Pressing the SET button
once more will store the scan result and lock all channels
that are used or subject to interference.
Releasing locked channels
̈ First, select the channel bank whose locked channels you
want to release (see “Switching between channel
banks” on page 21).
̈ Select the “SCAN” menu.
̈ Select “CLEAR” and confirm your selection by pressing
the SET button. All c hannels in this channel bank ca n
now be selected again.
Multi-channel operation
Combined with ew 500 G2 transmitters, the receiver can
form transmission links that can be used in multi-channel
systems. For multi-channel operation, only use the free
channels in a channel bank.
Before putting the transmission links into operation, we
recommend performing an auto scan.
̈ Select a channel bank on a receiver.
̈ Scan this channel bank for free channels. If not enough
free channels are available in the selected channel bank,
repeat the scan with another channel bank.
̈ Apply the scan result to all other receivers and
transmitters.