Filter
Top Products
Remove:
1. all packing materials from inside the oven cavity. Check to see that there are
Installation Instructions, Wall Template and Top Template. Read enclosures and
SAVE the Operation Manual.
2. the feature sticker, if there is one, from the outside of the door.
Check the oven for any damage, such as misaligned or bent door, damaged door
seals and sealing surfaces, broken or loose door hinges and latches and dents inside
the cavity oron the door. If there is any damage, do not operate the oven and contact
your dealer or SHARP AUTHORIZED SERVICER.
See Installation Instructions for more details.
Door seals and
sealing surfaces
UNPACKING INSTRUCTIONS
Unpacking and Examining Your Oven
Carefully remove oven from carton. SAVE THE CARTON AS IT MAY MAKE
INSTALLATION EASIER.
ACCESSORIES
Two accessories are available for this oven:
1. Charcoal Fitter Kit (RK-220). This is required when hood exhaust is recirculated. See Charcoal Fitter Krt on page 27.
If your dealer does not stock this item, rt can be ordered by calling 1-800-BE-SHARP.
2. Filler Panel Kit. For use when the oven is installed in a 36-inch or 42-inch wide opening. The metal filler panels come in pairs,
each 3.inches wide. For information contact: Modern-Aire Manufacturing Corporation
7319 Lankershim Blvd.
North Hollywood, CA 91605
Phone: (818) 765-9870 or (213) 875-1350 Fax (818) 765-4916
GROUNDING INSTRUCTIONS
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a groundin9 plug. It must be
plugged into a wall receptacle that is properly installed and grounded in accordance with the National Electrical Code and local
codes and ordinances. In the event of an electrical short circuit, grounding reduces risk of electric shock by providing an escape
wire for the electric current.
WARNING
-Improper use of the grounding plug can result in a risk of electric shock.
Electrical Requirements
Check Installation Instructions for proper location for the power supply.
The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more protected
electrical supply. It is recommended that a separate circuit serving only the oven be
provided.
The oven is equipped with a 3-prong grounding plug. It must be plu9g
ed
into a wall
receptacle that is properly installed and qrounded. DO NOT UNDER ANY
CIRCUMSTANCES CUT OR REMOVE THE GROUNDING PIN FROM THE PLUG.
3-Prong Plug
~
1
Grounding Pin
Ground
Receptacle Box
Note:
1.
If
you have any questions
about
the grounding or electrical instructions, consult a qualified electrician or serviceperson.
2. Nerther Sharp nor the dealer can accept any liability for damage to the oven or personal injury resuhing from failure to observe
the correct electrical connection procedures.
Radio or TV Interference
Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave oven is on a
d~lerent electrical circuit, relocate the radio or TV as far away from the oven as feasible or check position and signal of receiving
antenna.
4