Filter
Top Products
- 10 -
After removing the bread, immediately rinse the
baking mould ¶ with warm water. This prevents
the kneading paddles ² from sticking to the
driving shaft.
Tip: If you remove the kneading paddles ² after
the last kneading of the dough, the bread will
remain intact when you remove it from the
baking mould ¶.
• Briefly press the Start/Stop button ạ to interrupt
the programme at the very start of the baking
phase or, remove the power plug from the wall
socket. Ensure that you re-insert the power plug
within 10 minutes so that the baking process can
be continued.
• Open the appliance lid ᕢ and remove the
baking mould ¶. You can take the dough out
with floured hands and remove the kneading
paddles ².
• Lay the dough back into the baking mould ¶.
Replace the baking mould ¶ and close the
appliance lid ᕢ.
• Insert the power plug into the wall socket. The
baking programme continues from where it
was stopped.
Allow the bread to cool for 15-30 minutes before
eating it.
Before cutting the bread, ensure that the kneading
paddles have been removed ².
Error Messages
•If the display Ạ shows "HHH" after the program-
me has been started, it indicates that the tempe-
rature in the Bread Baking Machine is still too
high. Stop the programme and remove the power
plug. Open the appliance lid ᕢ and allow the ma-
chine to cool down for 20 minutes before re-
using it.
• If a new Programme cannot be started directly
after the Bread Baking Machine has completed
a baking process, it means the appliance is still
too hot. In this case the display panel reverts to
the default setting (Programmme 1). Open the
appliance lid ᕢ and allow the machine to cool
down for 20 minutes before re-using it.
ƽ Warning
Do not attempt to take the appliance into use befo-
re it has cooled itself down. This functions only with
programmes 11 and 12.
• If the display shows "EE0", "EE1" or "LLL" after
the programme has been started, first of all
switch the Bread Baking Machine off and then
back on by removing and then re-inserting the
power plug from/into the wall socket. Should the
error display continue, make contact with
Customer Services.
Cleaning and Care
ƽ Warning
Before cleaning it, always remove the power plug
from the wall socket and allow the appliance to
cool down completely.
Protect the appliance against moisture, this could
cause you to receive an electric shock.
Please also observe the safety instructions.
ƽ Important
The appliance and its ancillaries are not suitable
for being cleaned in a dish washing machine!
Housing, lid, baking space
Remove all particles left behind inside the baking
area using a wet cloth or a slightly wet soft spon-
ge. Wipe the housing and the lid too, only with a
moist cloth or sponge.