Filter
Top Products
14
Something not working
IMPORTANT!
The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights, which can be solved
with the help of the indications described in the chart, without calling out a service technician.
Switch off the dishwasher, open the door and carry out the following suggested corrective actions.
Fault code / malfunction Possible cause Solution
The dishwasher does not fill with
water.
- continuous flashing of the
start/cancel indicator light
- repeating single flash of the
"Finished" indicator light
The water tap is blocked or furred Clean the water tap.
with limescale.
The water tap is turned off. Turn the water tap on.
The filter (where present) in the Clean the filter in the.
threaded hose fitting at the water threaded hose fitting.
inlet valve is blocked.
The water inlet hose has not been Check the water inlet hose
correctly laid or it is bent or connection.
squashed.
The dishwasher will not drain.
- continuous flashing of the
start/cancel indicator light
- repeating double flash of the
"Finished" indicator light
The sink spigot is blocked. Clean out the sink spigot.
The water drain hose has not been Check the water drain hose
correctly laid or it is bent or connection.
squashed.
The programme does not start.
The dishwasher door has not been Close the door
properly closed.
The main plug is not plugged in. Insert the mains plug
The fuse has blown in the household Replace the fuse.
fuse box.
Delay start has been selected. If dishes are to be washed
immediately, cancel the delay
start.
Once these checks have been carried out; close the door, switch on the dishwasher and press the
start/cancel button. The program will continue from the point at which it was interrupted. If the
malfunction or fault code reappears contact your Customer Care Centre.
For other combinations of fault codes not described in the above chart, please contact your
Customer Care Centre.
156998841.qxp 12/13/2006 3:34 PM Page 14