Filter
Top Products
20
Fitting under a counter
By removing the dishwasher’s worktop, you
can install it under a close fitting sink unit or a
pre-existing top.
Be sure that once the appliance has been
installed, it is easily accessible for the service
engineer in the event that a repair is required.
Unscrew the two screws
at the rear.
Push the top backwards
about 1 cm.
Lift top at the front and
remove it.
Check if the dishwasher
is levelled.
If not, loosen or tighten
the adjustable feet until
the appliance is
perfectly levelled.
Levelling
Good levelling is essential for correct
closure and sealing of the door.
When the appliance is correctly levelled,
the door will not catch on either side of the
cabinet.
156998841.qxp 12/13/2006 3:34 PM Page 20