Filter
Top Products
User instructions
32
3.3 Washing programs
The dishwasher is equipped with a control panel and an
INFORMATION DISPLAY (9)
from which
it is possible to carry out all the power switch-on, switch-off and programming operations.
Before starting a washing program make sure that:
•
The water supply tap is
open.
•
The
correct amount of detergent
has been added to the
dispenser
.
•
The baskets have been
correctly loaded.
•
The spray arms are able to
rotate freely
and without obstruction.
•
The dishwasher door is
securely closed
.
HALF LOAD WASH FUNCTION
This function is recommended for loads of up to
7 place-settings
, and cuts down on the use of
water and electricity.
By pressing the
½ LOAD WASH (3)
button it is possible to select only one basket washing (upper
or lower).
After having the program selected, continue as follows:
•
by pressing for one time the
½ LOAD WASH (3)
button, it will
select the upper basket and on the display will compare the
following visualization;
•
by pressing the
½ LOAD WASH (3)
button again the lower
basket is selected;
•
by pressing a third time the
½ LOAD WASH (3)
button it will bring back to the full load washing
mode.
N.B.:
by selecting the
½ LOAD
mode, a modification in the indication of the program duration will
set.
One half of the cutlery basket can be placed in the
½ LOAD
program basket.
WARNING: do not load dishes and cutlery into the non-selected basket, because the water
spray will only reach the selected basket.
DELAYING THE PROGRAM
The
PROGRAM DELAY
button
(5)
can be pressed to delay the start of the program by up to
12 hours
.
This means that the dishwasher can be operated at the time of day of your choice.
The first time the
PROGRAM DELAY
button
(5)
is pressed the display will show
12 hours
, the
maximum delay time before the program will start. Each subsequent time the button is pressed the
delay time will be reduced, until the desired delay time is reached.
Particularly, on the display it will have the following indications.