Filter
Top Products
User instructions
33
Chosen the delay, proceed with the program start, press the button
START/PAUSE (6)
for same
seconds until the clock symbol start to flaash.
The machine will perform a dish pre-washing, and when finish, the “delay program” will enter in
function as it was first set.
In case you want to put to zero the “delay program” within the running program it is necessary:
•
to press the
START/STOP (6)
button for some seconds until the clock symbol remain lid up on
the display;
•
to press the
DELAY PROGRAM (5)
more times until the reset of the delay program (clock
symbol shut off);
•
to press the
START/STOP (6)
button to make start the program.
N.B.:
It is not possible to select the “
delay program
” when the program have already began.
TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT
•
Always try to run the dishwasher
fully loaded
.
•
Do not wash the dishes in running water.
•
Use the washing program that is
most appropriate
for each type of load.
•
Do not carry out any preliminary rinsing.
•
If available, connect the dishwasher to a hot water supply up to 60°C.
•
When possible,
skip the drying cycle
by leaving the door open when the washing cycle is
complete; the air and the residual heat will dry the dishes perfectly.
TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT
The phosphates contained in dishwasher detergents are harmful to the environment. To avoid
using excessive amounts of detergent and to save on electricity, observe the following:
• separate
the more delicate items from dishes that are more resistant to aggressive detergents
and high temperatures;
• do not pour
the detergent directly on the dishes.
REMOVING THE DISHES
At the end of the washing program, wait at least
20 minutes
before removing the dishes, to allow
them to cool down. To prevent any water droplets on the upper basket from falling on the dishes in
the lower basket, it is
advisable
to unload the lower basket first, and then the upper basket.