Filter
Top Products
Instructions for the User
26
14.EXTRAORDINARY MAINTENANCE
Occasionally, the oven will require minor servicing procedures or the replacement of parts subject to
wear and tear, such as gaskets, light bulbs, etc. The specific operations for each procedure of this kind
are provided below.
Before carrying out any operation involving access to live parts, disconnect the appliance from the
electricity supply.
14.1 Changing the light bulb
Remove the protective cover A by unscrewing it anticlockwise and replace the bulb B with another of the
same type. Replace the protective cover A.
Use only light bulbs approved for ovens (T 300°C).
14.2 Removing the door
14.2.1 With mobile levers of type 1
With the door completely open, lift the levers A until they touch
the hinges B and take hold of the two sides of the door with both
hands close to the hinges. Raise the door to an angle of about
45° and remove it. If the hinges have not locked, repeat the
operation, raising the levers A and keeping the door slightly
raised. To reassemble, fit the hinges B into their grooves, then
lower the door into place, ensuring that it remains fitted into the
grooves C, then lower the levers A.
1)
14.2.2 With mobile levers of type 2
Lift the levers B and take hold of the two sides of the door with
both hands close to the hinges A.
Raise the door to an angle of about 45° and remove it. To
reassemble, fit the hinges A into their grooves, then lower the
door into place and engage the levers B.
2)
14.2.3 Removing doors with pins
Open the door completely and insert the pins (supplied) into the holes from the inside. Close the door to
an angle of about 45° and lift it off. To reassemble, fit the hinges into their grooves, then lower the door
into place and extract the pins.