Filter
Top Products
56
Instructions for the user
7.4.2 Removing the door with pins
Open the door completely and insert the pins (supplied) into the holes
from the inside. Close the door to an angle of about 45° and lift it off. To
reassemble, fit the hinges into their grooves, then lower the door into
place and extract the pins. If the pins get lost, two screwdrivers can also
be used.
7.5 Removing the glass panels
The glass in the door should always be kept thoroughly clean. For
easier cleaning, the door glazing can be fully removed by proceeding
as described below. After opening the door and locking it in place as
described in point “7.4 Removing the door”, remove the internal glass
pane levering it as illustrated in figure 1, and detach the 4 pins that fix
the glass to the door. If your oven also has a middle glass pane (figure
2) this can be extracted simply by lifting it upwards. After having carried
out the cleaning, first of all replace the middle glass panel (if your oven
has one), and then position the internal glass hinging it, as shown in
figure 3, on the grooves of the oven door (see part A in figure 3). When
the glazing has been positioned on the door, exert a slight pressure on
the four fixing pins.
If the door should close during these operations, simply relock one of
the hinges as described in point “7.4 Removing the door”. The glass
panels can now be washed separately.