Filter
Top Products
Instructions for the Installer
2.2 Positioning the oven
The appliance is designed for building-in to cabinets made from any heat-
resistant material. Comply with the dimensions shown in figures 1, 2, and 3.
When installing under worktops, comply with the dimensions shown in figure
1-3.
When installing under worktops incorporating combined hobs, a gap of at
least 110 mm must be left from any side wall, as shown in figure 1.
When installing in tall units, comply with the dimensions shown in figure 1-2,
bearing in mind that the top/rear of the unit must have an opening 80-90 mm
deep.
Screw the 4 screws A into the inside of the frame (fig. 1).
For installation under tops, make sure that the rear/bottom of the unit has an
opening similar to that shown in figure 1 (ref. B). See the instructions supplied
with the hob for the relative positioning and fixing procedures.
32