Filter
Top Products
Continuous Loss-in-Weight Blenders Chapter 3: Installation 42
All alarm parameters are selectable.
If you do not want to use an alarm for a feeder, ensure the corresponding box has an “N” in it.
To be enabled, the box must have a “Y” in it.
You can also decide to let the Blender continue to Run or Stop if an alarm is active. To do this,
select “Stop” or “Run” in the boxes on the right.
“Pop-ups enabled” means the alarms will be shown on the screen. Select “Pop-ups disabled”
if you don’t want to see the alarms on the screen.
“Extruder flow alarm” and “Blender cannot keep up alarm” can be enabled or disabled
according to costumer requirements.
Communications
All Allen-Bradley Loss-in-weight blenders can be setup to communicate to a host via Ethernet,
an optional Ethernet module must be purchased to allow communications. This can be used for
loss-in-weight extrusion control or for data monitoring. The window below shows how to set
up the 1761ENI Ethernet module.