Filter
Top Products
BJ5-615 Chapter 5: Maintenance 44 of 85
Dismounting the Cutter Holders
1. Switch OFF the shredder at the main switch
2. Safeguard main switch using a padlock.
3. Open the lower machine door.
4. Safeguard the machine door.
5. Remove screen
NOTE: Although it is possible to reach the cutting shaft by climbing into the
feeding chamber, it is recommended to access the cutters through the
machine door located at the front of the machine. The shaft can be rotated
manually by turning the motor v-belt pulley.
6. Clean the hexagon head socket of the cutter mounting screw (2).
7. Loose the screw using a high quality Allen key (10 mm). If necessary knock the
Allen key lightly with a hammer to loose it.
8. Take out the cutter mounting screw, the washer and the cutter.
9. Clean the hexagon head socket of the cutter holder mounting screws (4).
10. Loose the screw using a high quality Allen key (6 mm). Knock the Allen key
lightly with a hammer to loose it if necessary.
11. Take out the cutter holder mounting screws.
12. Remove the cutter holder with the delivered Extractor.
NOTE: See previous drawing.
4
1
2
3
(1) Cutter
(2) Cutter mounting screw
(3) Cutter holder
(4) Cutter holder mounting
screws