Filter
Top Products
BJ5-615 Chapter 5: Maintenance 46 of 85
WARNING! Danger of cutting caused by sharp cutters at all times—even when rotor is at
standstill. Serious Injury especially to the hands and fingers can occur. Wear protective
gloves!
Mounting the Cutter Holders
1. Clean the cutter pocket and the cutter holder.
2. Insert cutter holder into the pocket.
NOTE: Cutter holder must slide in easily. Do not damage the cutter holder
surfaces with a hammer.
3. Put in the cutter holder mounting screws (DIN912 – M8x25 – 12.9) and put some
Loctite on them.
4. Make sure that the cutter holder fits properly.
5. Tighten the cutter mounting screws using a torque wrench.
NOTE: The required torque for the cutter holder mounting screws is 39 Nm
(also see the table under “Working on Cutting Cutters”).
WARNING! Danger of cutting caused by sharp cutters at all times—even when rotor is at
standstill. Serious Injury especially to the hands and fingers can occur. Wear protective
gloves!
(1) Bed knife
(2) Knife mounting screws
(3) Knife holder
(4) Cover plates
(5) Knife adjusting screw for
pushing
(6) Cutter adjusting screw for
pulling
(7) Cover plate mounting
screws
1
2
6
5
3
4
7