Filter
Top Products
7
SECTION 3
INITIAL SET-UP AND OPERATION
3.1 OPERATOR’S SAFETY PRECAUTIONS
SAFE OPERATION IS NO ACCIDENT; observe these
rules:
A. Know the freezer. Read and understand the
Operating Instructions.
B. Notice all warning labels on the freezer.
C. Wear proper clothing. Avoid loose fitting garments,
and remove watches, rings or jewelry that could
cause a serious accident.
D. Maintain a clean work area. Avoid accidents by
cleaning up the area and keeping it clean.
E. Stay alert at all times. Know which switch, push
button or control you are about to use and what
effect it is going to have.
F. Disconnect electrical cord for maintenance. Never
attempt to repair or perform maintenance on the
freezer until the main electrical power has been
disconnected.
G. Do not operate under unsafe operating conditions.
Never operate the freezer if unusual or excessive
noise or vibration occurs.
3.2 OPERATING CONTROLS AND INDICATORS
Before operating the freezer, it is required that the operator
know the function of each operating control. Refer to
Figure 3-1 for the location of the operating controls on the
freezer.
A. Spigot Switch
The spigot switch will automatically start the auger
drive and refrigeration systems when the spigot is
opened to dispense product. When the spigot is
closed, the drive motor and compressor will remain
on until the product in the freezing cylinder reaches
the proper consistency..
WARNING
High voltage will shock, burn or cause death. The
OFF-ON switch must be placed in the OFF position
prior to disassembling for cleaning or servicing. Do
not operate machine with cabinet panels removed.
Figure 3-1 Freezer Controls
Consistency
Adjustment
Knob
Diagnostic
Light
Add Mix
Indicator
Clean/Off/On
Switch