Filter
Top Products
PAGE 18 — STOW MS-93 MIXER — OPERATION MANUAL — REV. #5 (03/26/10)
STOW MS-93 PLASTER/MORTAR MIXER — ELECTRIC MOTOR
Special attention should be given to the electric switch as
well as the over-and-under voltage protection devices as per
regulations set forth in the local electrical safety code handbook
NOTE
Figure 7. Single Phase Electric Motor With
12-inch Pigtail
Electric Motor
For maintenance care and operation of the electric motor,
refer to your electric motor instruction booklet furnished with
the motor.
Protect the electric motor from dust as much as possible and
keep ventilating openings clean.
DO NOT spray water at any time on the electric motor.
DO NOT operate electric motor in a explosive environment.
The electric motor used in this mixer is a single-phase 3
HP motor. The input voltage requirement for this motor is
115/230 VAC, and has been pre-set to 230VAC.
Electric Motor Connection
A 12-inch electrical cable (Figure 7) is provided with the elec-
trical motor for hookup to a power source. Table 5 shows the
required NEMA connector for the desired motor horsepower
rating. In addition, Table 5 also shows the matching NEMA
approved connector for the required extension cord.
CAUTION
ALWAYS make certain that the power source required for
the electric motor is correct and always use the correct
NEMA configuration plug. Failure to supply the correct
voltage to the motor can severely damage the motor.
CAUTION
Electric Motor
Connections
Electric Motor
Safety
It is strongly recommended that all
electrical wiring be done by a licensed
electrician.
noitamrofnIgniriWrotoMcirtcelE.5elbaT
rotoM
rewopesroH
gnitaR
esahPelgniS-CAV032-511
rotcennoCgulPAMEN AMENgnitaM
rotcennoCelcatpeceR
PH0.2
)CAV511(
735049MEN/PP02-5L 835049MEN/PR02-5L
PH0.2
)CAV032(
935049N/PP02-6L 045049N/PR02-6L