Filter
Top Products
STOW MS-93 MIXER — OPERATION MANUAL — REV. #5 (03/26/10) — PAGE 19
Electric Motor Voltage Switch
1. ALWAYS make certain the motor switch is "OFF" and the
power cord has been disconnected from the power source.
2. Remove the voltage lock-out bolt (Figure 7). Change the
position of the voltage change toggle switch from 115
VAC to 230 VAC. The mixer is factory wired for 115 VAC
operation.
3. Replace the voltage lock-out bolt.
4. Important!, when changing the input voltage to the motor
from 115 to 230 VAC, the plug on the motor power cord
must also be changed. See Table 5.
The motor supplied is wired for 115 VAC grounded operation.
Make certain that the correct size grounded (3-wires) extension
cord is used. See Table 6.
Motors can burn out when the line voltage falls 10% below the
voltage rating of the motor. Failure to use proper voltage will
cause the motor to overheat and actuate the overload switch.
If overload protection should actuate because of improper volt-
age or any other malfunction, turn the main switch on the motor
to the "OFF" position and correct the problem, press the reset
switch button, and turn the main switch to the "ON" position.
eziSdroCnoisnetxEdednemmoceR.6elbaT ss
s
ss
ledoM rotoM egatloV
.tf05
)m42.51(
.tf57
)m68.22(
.tf001
)m84.03(
.tf002
)m69.06(
E39SM
)cirtcelE(
PH0.2
511 21.oN 01.oN 8.oN 6.oN
032 41.oN 21.oN 21.oN 8.oN
STOW MS-93 PLASTER/MORTAR MIXER — ELECTRIC MOTOR