Filter
Top Products
PAGE 24 — STOW MS-93 MIXER — OPERATION MANUAL — REV. #5 (03/26/10)
4. Turn the engine switch (Figure 14) to the ON position.
5. The main start/stop switch located on the engine cover
is (Figure 15) is used to start and stop the engine. Pull
this switch outward to start the engine.
6. Place the belt slip lever (Figure 16) in the START/STOP
(disengaged) position.
Figure 16. Belt Slip Lever
(Start/Stop Position)
7. Pull the starter grip (Figure 19) lightly until you feel
resistance, then pull briskly. Return the starter grip gently.
Figure 19. Starter Grip
Figure 18. Drum Lock Pin (Right Position)
Figure 17. Drum Lock Pin (Side-View)
Make certain the drum lock pin (Figures 17 and 18) is
placed to the RIGHT (when viewing the mixer from the
towpole end) of the drum stop block which is welded to
the front side of the drum. Also make sure lock pin is fully
engaged (locked). This will prevent the drum from tipping.
CAUTION
Figure 15. Start/Stop Switch (gasoline engine)
Figure 14. Engine ON/OFF Switch
Preventing Drum Tipping
MS-93 PLASTER/MORTAR MIXER —
START-UP PROCEDURES