Sub-Zero 427RG Refrigerator User Manual


 
Models 427G and 427RG Installation 21
subzero.com
Uncrate the wine storage unit and inspect for any damage.
Remove the wood base and discard the shipping bolts
that hold the wood base to the bottom of the unit. Remove
all packing materials and tape.
All roller-assembly wine shelves should be removed to
reduce weight and prevent them from rolling. To remove,
pull the shelf out to its full extension, gently and evenly lift
up on both sides of the front of the shelf and remove.
Reverse the procedure to reinstall the shelf.
For model 427RG, the drawers should be removed and
placed aside until you are ready for installation of the
panels. Remove the decorative top and side moldings and
the kickplate/grille.
IMPORTANT NOTE: For model 427RG, the top drawer has
a control cable that needs to be disconnected before
removing this drawer. Refer to the illustration below for
placement and how to disconnect this fitting.
Before moving the wine storage unit into position,
secure the door closed, remove drawers (427RG) and
protect any finished flooring.
Unpack the Unit
Control cable.
DUAL INSTALLATIONS
When two model 427G, 427RG or integrated units are
installed closer than 2"
(51) to one another, it is necessary
to use the dual installation heater kit. The heater from this
kit must be attached to the left side exterior of the right-
hand unit before the unit is slid into position. The dual
installation heater kit and additional instructions is avail-
able through your authorized Sub-Zero dealer, or call
Sub-Zero customer care at 800-222-7820. You can also
visit our website at subzero.com.
LOCK INSTALLATION
For models 427G and 427RG, the optional lock is
attached to the decorative door panel through a field-
drilled hole in the panel. The catch should be installed on
the top of appliance cabinet before the unit is moved into
position. The accessory lock kit and additional instructions
are available through your authorized Sub-Zero dealer, or
call Sub-Zero customer care at 800-222-7820. You can
also visit our website at subzero.com.
IMPORTANT NOTE: For accessory stainless steel panels
requiring a lock, panels must be ordered with the lock
mounting hole pre-drilled.