Filter
Top Products
Door Panels
M
odels 427G and 427RG have a full-view glass door.
Each of these wine storage units are set up at the job site
as either the stainless steel or integrated design.
Stainless steel panels are available as sales accessories
and are shipped separately. Stainless steel panels are
shipped with matching handles in place.
The integrated design uses custom wood or other decora-
tive panels and handles provided by the customer.
Model 427RG requires solid panels on the drawers that
may match the door panel, or be complementary. The
model 427RG stainless steel drawer panel set and stain-
less steel door panel are ordered and shipped as two
items.
Before beginning installation, check for the correct
components for the fit and finish desired. The door and
drawers (model 427R) require a decorative panel that is a
minimum
5
/8" (16) thick.
IMPORTANT NOTE: For installations at or above 5,000'
(1524 m) in altitude, a special high altitude glass door unit
(HAG) must be ordered.
If you have questions, contact your authorized Sub-Zero
dealer or cabinet supplier. Additional panel information
can be found in the Sub-Zero design guide, or visit our
website at subzero.com.
Models 427G and 427RG Installation 25
subzero.com
Kickplate/Grille Installation
O
nce the wine storage unit is leveled and wiring connec-
tions made, the kickplate/grille can be installed. The
mounting bracket may be adjusted slightly forward or
back so the kickplate/grille will fit flush with the sur-
rounding area. Refer to the illustration below.
The kickplate/grille must be removable for service. The
floor cannot interfere with removal.
Turn power back on to the electrical outlet.
IMPORTANT NOTE: The unit must be allowed to have
ventilation through the fins of the kickplate/grille. You may
cover the solid area, but do not block the fins. The door
panel or the lower drawer panel may hang in front of the
fins, but the baseboard molding must not cover them.
If you choose, the kickplate/grille may be painted another
color. Follow these steps: Rough up the surface to be
painted with fine grit sandpaper. Wipe with alcohol to
ensure that the surface is clean and dry. Use an appliance
or industrial grade, oil base, high gloss enamel paint.
A solid panel cannot be installed over the glass door,
as this may cause moisture to form behind the panel.
MOUNTING
BRACKET
Kickplate/grille installation.