Filter
Top Products
Models 427G and 427RG Installation 29
subzero.com
OPTIONAL 90° DOOR STOP
The door of models 427G and 427RG opens to 105°. A
90° door stop is built into the hinge system for installa-
tions where the door opening must be limited.
To engage the door stop, use the blade edge of a stand-
ard screwdriver and rotate the cam in the center portion of
the hinge. You must make this adjustment to both the
bottom and top hinge. Refer to the illustration below.
INSTALLATION CHECKLIST
When you have completed installation of the model 427G
or 427RG wine storage unit, refer to page 54 for an instal-
lation checklist and page 55 for service information.
90° door stop.
Side Panels
S
ide panels for models 427G and 427RG are not attached
to the unit. You must securely fasten the panels to the
adjacent cabinets and floor.
Panels should be fastened to the floor and walls using
L-brackets (hardware not provided). To help you move
the unit into place, rout out an area in the floor so the
L-bracket will sit flush with the floor level.
Complete the Installation
ANCHORING
Brackets and screws are provided for mounting the unit to
adjoining cabinets and side panels. Each unit has four
side-mounting clips on each side.
For dual installations or installations where you are not
attaching to a side wall, you must remove the side-
mounting clips before moving the unit into position. After
removing the clips, replace the screws into the appliance.
A dual installation heater kit is necessary for anchoring
two model 427G, 427RG or integrated units together. The
kit is available through your authorized Sub-Zero dealer, or
call Sub-Zero customer care at 800-222-7820. You can
also visit our website at subzero.com.