Filter
Top Products
Door
Frame
Overlay
Panel
Tenon Center
6 mm
Diameter
11 mm
Diameter
Glass
Gasket
Illus. 9 Illus. 10
IMPORTANT NOTE:
Install screws in all the
mounting holes in the door frame. The nature
of the door panel with a narrow outer rim and
no connecting center member requires the
support provided by the glass door.
After the door panel installation is complete,
apply the cover patches or plugs provided over
the holes on the inside surface of the door.
OVERLAY SOLID DOOR – MODEL ICB424
IMPORTANT NOTE:
The solid door panel for
the Model ICB424 must be a minimum of 16
mm thick and cannot exceed 9 kg.
Installation of the solid door panel is the same
as the door panel for a glass door model.
HINGE ADJUSTMENT
IMPORTANT NOTE:
The Wine Storage unit
must be installed and leveled before door
hinge adjustments can be made.
The top and bottom cabinet hinges on Models
ICB424 and ICB424FS are held in place with
three permanent adjustment screws and two
shipping screws. Refer to illustrations 11 and
12 below. The shipping screws must be
removed and discarded to adjust the door
alignment and fit. If no adjustments are neces-
sary, it is recommended that all five screws
remain in place.
On the Model ICB424FS, only the bottom door
hinge can be adjusted. Remove and discard
the two shipping screws and loosen the three
hinge screws to adjust the door. Refer to
illustration 12.
COMPLETING THE INSTALLATION
IMPORTANT NOTE:
When you have
completed the installation of the Model ICB424
or ICB424FS Wine Storage unit, refer to pages
34–35 for the Installation Checklist and Service
Information.
A solid panel must not be installed on a
glass door unit, as this may cause
moisture to form behind the panel.
The cover patches or plugs are part of the
insulation system on the door of the Wine
Storage unit. Be sure to cover all the
holes in the door that were used.
11
MODELS ICB424 AND ICB424FS INSTALLATION
MODELS
ICB424
ICB424FS
Top Door Hinge
Shipping
Screws
Shipping
Screws
Bottom
Door Hinge
Illus. 11 Illus. 12