Filter
Top Products
16
POSITION THE UNIT
IMPORTANT NOTE:
If you are adding an
accessory lock kit to your Model ICB427 or
ICB427R, the catch should be installed at the
top of appliance cabinet before you position
the unit. See Lock Installation on page 23.
Installation instructions are included with the
lock kit.
Remove the decorative top and side moldings
and the kickplate/grille of the Wine Storage
unit.
IMPORTANT NOTE:
If for any reason the Wine
Storage unit has been laid on its back or side,
you must allow the unit to stand upright for a
minimum of 24 hours before connecting
power.
Plug the power supply cord into the 10 amp
grounded electrical outlet. With power applied
to the appliance, check for lighting and cooling
before going any further. Once you are satis-
fied that the unit is operating properly, shut off
power to the electrical outlet at the circuit
breaker and proceed.
If a home alarm system is to be used with the
Wine Storage unit, the lead wires should be
threaded into the compressor compartment
before you position the unit. See Other Wiring
Connections on page 18 for the location of
these lead wires. After the unit is in position,
the alarm wiring can be completed from the
front.
Pre-level the Wine Storage unit before rolling
into position. This is to allow the unit to
engage the anti-tip bracket properly.
Roll the unit into position, making sure the
anti-tip bracket is engaged properly. Screw the
front leveling legs out approximately 5 mm to
make any future adjustments easier.
IMPORTANT NOTE:
When the Wine Storage
unit is installed, the anti-tip bracket will be
positioned just below the engaging bracket on
the unit. It is not necessary to raise the unit up
so that it locks into the anti-tip bracket, but the
unit must be in alignment with the anti-tip
bracket.
IMPORTANT NOTE:
The floor under the Wine
Storage unit must be at the same level as the
surrounding finished floor to allow for removal
of the unit for servicing.
MODELS ICB427 AND ICB427R INSTALLATION
Shut off the power to the electrical outlet.
MODELS
ICB427
ICB427R