Filter
Top Products
11
INTEGRATED INSTALLATION INSTRUCTIONS
PANEL CONSIDERATIONS
DOOR AND DRAWER PANELS
To install door and drawer panels, refer to the
instructions under Panel Installation on page
18. You should check panel dimensions and
placement before proceeding with installation
of the Integrated unit. If you have questions,
contact your Sub-Zero dealer or cabinet
supplier. Instructions regarding sizing of the
panels are provided in the Sub-Zero Design
Guide.
IMPORTANT NOTE:
A portion of the backside
of the decorative panels will need to be
finished, as they will be exposed when the
doors are open.
SIDE PANELS
Side panels for integrated models are not
attached to the unit. You must securely fasten
the panels to adjacent cabinets and floor.
Panels should be fastened to the floor and
walls using ’L’ brackets (hardware not
provided). To help you move the unit into
place, rout out an area in the floor so the ’L’
bracket will sit flush with the floor level.
Brackets and screws are provided for
mounting the unit to adjoining cabinets and
side panels. On the tall units, there are four
side mounting clips on each side and on the
base units, there are two per side. Side panels
must be a minimum of 19 mm thick.
IMPORTANT NOTE:
For installations where
you are not attaching to a side wall or you are
installing two Integrated units together, you
must remove the clips before moving the unit
into place. After removing the clips, replace
the screws in the holes and discard the clips.
Optional components are necessary for
anchoring two Integrated units together. Refer
to Dual Installations on page 21. Optional
components are available through your
Sub-Zero dealer. To obtain local dealer infor-
mation, visit our website, subzero.com.
PANEL
DESIGN
Additional panel
design information
can be found in
the Sub-Zero
Design Guide.
Check our website
at subzero.com.