Filter
Top Products
Built-In Refrigeration 19
subzero.com/specs
Dispenser
MODEL ICBBI-48SD
The refrigerator door panel must include a cut-out to
accommodate the dispenser glasswell and bezel. The
thickness of the panel in this area can range from 6 mm to
a maximum of 29 mm.
IMPORTANT NOTE: Regardless of the thickness of the
panel for model ICBBI-48SD, you must plan for a flat
landing area for the decorative bezel surrounding the
glasswell area. The illustration to the right provides exact
bezel dimensions. Refer to the appropriate panel specifi-
cations page for exact cut-out location. This landing area
can be accomplished in a number of different ways.
One option (flush) is to rout the panel so the bezel will be
flush with rails and stiles. You must rout a space to
accommodate the height and width of the bezel. The
width of the stile immediately to the left of the bezel must
be 44 mm. Do not cut the entire stile to this dimension.
The other option (proud) shows a boxed out landing area
for the bezel using stiles and rails to create this space. In
this application, the bezel will sit proud of the stiles and
rails. The total thickness of the panels at this level must
not exceed 29 mm.
Handle placement.
51 mm
25
mm
GLASSWELL
HANDLE
160 mm
2 mm
3 mm
RADIUS
16 mm
327
mm
Dispenser dimensions.
For overlay and flush inset models, mounting placement of
the refrigerator door handle must assure proper access to
the glasswell and adequate clearance under the handle.
The handle placement illustration shows the relation of the
refrigerator door handle to the glasswell bezel on stainless
steel models.