Filter
Top Products
Wine Storage 65
subzero.com/specs
Handle Hardware
For overlay and integrated models, handle hardware must
be provided. Optional stainless steel tubular and pro
handles are avail able through your authorized Sub-Zero
dealer.
The door frame has numerous mounting holes on each
side to accommodate handle hardware. Using the pre-
drilled holes to attach the handle will provide the best
alignment and strength.
IMPORTANT NOTE: Refer to the full-scale template at the
end of this section for a profile of the door frame and
position of the glass. Do not drill through the glass.
Side Panels
MODEL ICBWS-30
When planning for side panels with the installation of the
model ICBWS-30, you need to be aware of the space con-
figuration to achieve a pleasing fit. Depending on the exact
panel you are using, the height of the panel may vary.
IMPORTANT NOTE: The use of side panels may change
the width of your rough opening.
When installing a model ICBWS-30 with a custom side
panel, an accessory kit (7003407) is required. Stainless
steel side panels are also avail able through your author-
ized Sub-Zero dealer.
The side panel will need to be a minimum of 610 mm deep
and 13 mm thick. Refer to the illustrations below for side
panel dimensions. Routing will be necessary so that the
side panel fits flush against the side of the unit.
Routing detail.
MAIN
FRAME
SIDE PANEL
ROUTING
25 mm
48 mm
3 mm
13 mm
2134
mm
610 mm
OPTIONAL
TOE KICK
CUT-OUT
102 mm
48 mm
25 mm
ROUT TO 3 mm
FRONT
OF SIDE
PANEL
67 mm
Side panel dimensions.