Filter
Top Products
Wine Storage 63
subzero.com/specs
Model ICBWS-30
DUAL FLUSH INSET INSTALLATIONS
Installing two models ICBWS-30 or a model ICBWS-30
and built-in unit side by side in a flush inset application will
require adjustments to the dimensions of your finished
rough opening, panel sizes and panel offsets. It will also
require a dual installation kit, available through your
Sub-Zero dealer.
Dual installations without a filler strip can only be accom-
plished using two units with opposite hinges as shown in
illustration A below. The dual installations shown in illus-
trations B and C require a filler strip. Illustration A is the
only application that will accommodate the dual wide
grille.
IMPORTANT NOTE: The application shown in illustration A
can only be achieved by installing dual flush inset panels.
Failure to install dual flush inset panels will cause the
handle side of the panels to collide when closing. In this
application a dual installation accessory kit is also
required.
Dual flush inset panels and dual installation kits are avail-
able through your Sub-Zero dealer. Refer to the illustration
and chart for dual flush inset panel specifications.
Grille panel dimensions listed are for a standard 2134 mm
overall height of the unit. For a 2108 mm overall height,
subtract 25 mm from grille panel height dimensions. For a
2235 mm overall height, add 102 mm to height dimensions.
Width dimensions do not vary.
ICBWS-30 Dual Flush Inset
DOOR W H
Flush Inset Panel 775 mm 1772 mm
Spacer Panel 740 mm 1751 mm
Backer Panel 756 mm 1767 mm
GRILLE W H
Flush Inset Panel 775 mm 235 mm
Spacer Panel 740 mm 211 mm
Backer Panel 756 mm 227 mm
WINDOW W H
Cut-Out 584 mm 1581 mm
A
Location 95 mm
H
W
H
AA
A
A
Illus. A
WITHOUT FILLER STRIP
FILLER STRIP REQUIRED
FILLER STRIP REQUIRED
Illus. B Illus. C
DUAL FLUSH INSET PANEL SPECIFICATIONS