Filter
Top Products
Integrated Refrigeration 47
subzero.com/specs
Cabinetry Applications
Integrated refrigeration is compatible with virtually any
style and look of cabinetry. These models can be used
with framed as well as frameless cabinetry. Because of the
precise application and the look you may want to achieve,
keep the following considerations in mind:
The thickness of the front panels can vary. A minimum 16
mm thick panel is required, but the thickness can be
increased provided the panel weight limit is not exceeded.
IMPORTANT NOTE: The depth of each integrated model is
610 mm from the front of the unit to its back. You must
allow for the thickness of the panel you are applying when
planning for the finished rough opening depth if you want
the front panel to be flush with surrounding cabinetry. You
may have to move the unit back into drywall or bring the
cabinets forward to achieve a flush fit.
Reveals between panels can vary. A reveal of 3 mm is
typical, but reveals can be increased to up to 6 mm.
When 19 mm or thicker panels are used with a reveal of
less than 6 mm, door panels may cause damage to the
unit when the door is opened to the maximum 105°.
Use the built-in 90° door stop.
As reveals between cabinetry and the unit decrease,
the potential exists for severe finger pinching while the
door is closing.
IMPORTANT NOTE:
The inside edges of the rough opening
as well as the sides and a portion of the backside of the
decorative panels will need to be finished, as they will be
exposed when the doors are open.
D-style handles are recommended. For the cabinet door,
handles must be located near the edge of the panel
opposite the hinge, centered top to bottom. Locate
handles in the top center area of the drawer panels.
Illustrations on the following pages show typical applica-
tions of frameless and framed cabinetry. Also refer to the
full-scale illustration at the end of this section for specifics
on door openings.
Panel Requirements
TALL AND DRAWER MODELS MAX WEIGHT
686 mm Door Panel 18 kg
686 mm Drawer Panel 5 kg
914 mm Door Panel 24 kg
914 mm Drawer Panel 7 kg
PANEL THICKNESS MINIMUM
All Panels 16 mm