Filter
Top Products
19
In case of a spillage, you can take the following
steps to easily clean the exterior door:
To remove and replace the exterior door of your
Smart
Station you will need a small screwdriver:
1.
Open the exterior access door
2. Use the at part of the screwdriver to remove
the door from the base on the left hand side.
3.
Find the hinge and screw the screwdriver into
it.
4.
Once you have unscrewed the hinge, pull the
door to the right until it comes away.
5.
T
o replace the door, rst attach it to the bolt on
the right-hand side.
6.
Slide the edge to the right using the
screwdriver, and align it with the marked
groove.
7.
Use light movements until you hear a click
indicating that the door is properly positioned.
smart ll ice factory
(only available with certain models)
This no-spill ice-maker with removable cylinder feeds directly into the
ice-tray
. It comes with a storage box that can
hold up to 900g of ice.
starting up:
Remove the water cylinder found at the top
of the Smart Fill Ice Factory (SFIF) by pulling
the top middle part towards you.
Once removed, place the water cylinder on a
at surface. Open the top, which you’ll nd in
the middle centre. To avoid spillages, make
sure that there’s no residual ice obstructing
the valve of the cylinder before you ll it with
water. Pour 180 ml of puried water into the
cylinder or ll it to the maximum level.
Replace the top, placing pressure on the
middle. It’s essential that it’s secure in the
centre in order to avoid water leaking out.
Put the cylinder back in its original position
making sure it’s securely connected. You
should be able to see and hear the water
lling the ice-tray which indicates that the
cylinder is correctly installed.