Filter
Top Products
20
note: It’
s important that once you have completed the above steps you make
sure that the water cylinder is correctly installed to prevent water freezing in
the cylinder’s interior.
caution: Only ll with drinking water.
removal of ice
1. After a while, your ice cubes will be
ready for use. To remove them, pull the
handle slowly towards you until it’s fully
down. At this point it will be necessary
to pull the handle a little more forcefully
until you hear the ice fall into the lower
compartment of your Smart Fill Ice
Factory.
2.
This compartment can hold up 3
complete releases of the ice-tray. To
remove the ice, simply lift and pull the
storage box that you will nd in the lower
part. This box is designed to be brought
wherever you wish. To make more ice,
repeat the process.
note: The cylinder can only hold one load at
a time. Before repeating the process, make
sure that the tray is empty.
note: The ice produced may vary in size.
cleaning the smart ll ice factory
When cleaning your Smart
Fill Ice Factory it is imperative that you only use
a soft sponge with water and a neutral soap. Afterwards, leave it to dry.
DO NOT use a steel wool sponge or detergent to clean the SFIF (specially
the ice-bucket), as this could affect how it works, change how it looks, and
affect the avour of your ice cubes.
cleaning the cylinder
Only use a soft sponge with water and a neutral soap to clean.
Afterwards,
leave it to dry. Don’t use steel wool sponges or detergents, knives or forks
as these could scratch or damage the central valve. If there’s frozen water
inside the cylinder, let it melt or use tepid water to speed up the process.
important:
When removing the ice cubes, pull
the handle all the way down. You will feel resis-
tance at this point, but you need to pull a little more
so that the ice-tray twists and releases the ice into
the lower compartment. Once this point has been
reached, the process is complete.