Filter
Top Products
4
Wash the processing bowl and blades in
warm soapy water. Rinse well and dry
thoroughly.
Using the double blade attachment
1. Place the non-slip pad on a flat level
surface and position the processing bowl
on top of it. Remove protective cover from
blades.
2. Place the lower blade over the shroud in
the centre of the processing bowl.
See Figure 1.
3. Position the upper blade on top of the
lower blade. See Figure 2.
NOTE: Whether the upper blade is used will
depend on the chopping task.
4. Place the food items to be chopped inside
the processing bowl. Large portions should
be cut into small pieces before chopping,
approximately 3cm cubes.
NOTE: Do not operate the appliance when the
processing bowl is empty.
5. Place the processing bowl cover on top of
the processing bowl and rotate clockwise
until the two parts are interlocked.
6. Place the motor housing on top of the
processing bowl cover. See Figure 3.
7. Hold down the motor housing with one
hand and press down on the power
button with the other hand to activate the
chopper. Use short pulses until the right
consistency is achieved.
Using your MultiChopper
™
Food Chopper
Figure 1
Figure 2
Figure 3