Sunbeam FC8600 Food Processor User Manual


 
1
If you have any concerns regarding the performance and use of your appliance,
please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line.
Ensure the above safety precautions are understood.
SAFETY PRECAUTIONS FOR YOUR
SUNBEAM MULTICHOPPER PLUS, CHOPPER
AND BLENDER.
Always operate on a flat surface.
Do not operate the appliance without the cover
in place.
Do not remove the motor housing from the jug
while the blades are still in motion.
Do not use the appliance continuously for more
than 7.5 seconds at a time.
Use extreme care when handling blades as
they are extremely sharp.
Do not blend hot ingredients.
Sunbeam’s Safety Precautions
Sunbeam are very safety conscious when
designing and manufacturing consumer products,
but it is essential that the product user also
exercise care when using an electrical appliance.
Listed below are precautions which are essential
for the safe use of an electrical appliance:
Read carefully and save all the instructions
provided with an appliance.
Always turn the power off at the power outlet
before you insert or remove a plug. Remove
by grasping the plug - do not pull on the cord.
Turn the power off and remove the plug
when the appliance is not in use and
before cleaning.
Do not use your appliance with an extension
cord unless this cord has been checked
and tested by a qualified technician or
service person.
Always use your appliance from a power
outlet of the voltage (A.C. only) marked
on the appliance.
Close supervision is necessary when your
appliance is being used near children or
infirm persons.
Young children should be supervised to ensure
that they do not play with the appliance.
Do not use an appliance for any purpose
other than its intended use.
Do not place an appliance on or near a hot
gas flame, electric element or in a heated
oven. Do not place on top of any other
appliance.
Do not immerse in water.
For safety reasons and to avoid maintenance
by unskilled persons, some appliances are
‘sealed’ using tamperproof screws. Such
appliances should always be returned to the
nearest Sunbeam Appointed Service Centre
for adjustment or repair if required.
Do not let the power cord of an appliance hang
over the edge of a table or bench top or touch
any hot surface.
Do not operate any electrical appliance with a
damaged cord or after the appliance has been
dropped or damaged in any manner. If damage
is suspected, return the appliance to the
nearest Sunbeam Appointed Service Centre
for examination, repair or adjustment.
For additional protection, Sunbeam
recommend the use of a residual current
device (RCD) with a tripping current not
exceeding 30mA in the electrical circuit
supplying power to your appliances.
Do not immerse the appliance in water
or any other liquid unless recommended.