Filter
Top Products
10
Heading
Before using your MultiProcessor
• Wash the processing bowl, cover and all
attachments in warm water using a mild
detergent. Dry each part thoroughly
before use.
• Before you assemble the food processor,
ensure that the power cord is unplugged.
Before using the processing bowl
• The following steps are only necessary for
the MultiProcessor Plus (LC6900).
1. Place the motor base facing you on a dry,
level surface.
2. Fit the safety cover onto the food processor
body. Simply place the safety cover and
twist anti-clockwise, see Figure 1.
Note:
The MultiProcessor Plus, processing
bowl will not operate if the safety cover or
blender jug are not in place.
Positioning the processing bowl and cover
The following steps are for both models
LC6200 and LC6900.
1. Place the motor base facing you on a dry,
level surface.
2. Position the processing bowl over the drive
shaft. The handle of the bowl needs to be
facing you and the bowl should now be
resting on the base of the food processor,
see Figure 2.
3.
To lock the bowl into position for use, turn the
handle to the right, as far as it will go
, see
Figure 3.
4.
Place the processor cover onto the
processing bowl, by positioning the ‘align’
label on the cover with the top of the handle
which is marked ‘rotate lid to lock’
, see
Figure 4.
UNLOCKED
Using your Sunbeam
MultiProcessor
LC6900
Pictured
LC6200
Pictured
LC6200
Pictured
LC6200
Pictured
Fig 1
Fig 2
Fig 3
Fig 4