Filter
Top Products
6
MINI-BLEND® JARS
MINI-BLEND
®
Jars, 8-ounce (250 ml) or 30-ounce (950 ml), are available as accessories and are not
normally included with your Blender. For proper assembly and tightening instructions, see directions
above and on previous page. The MINI-BLEND
®
Jars allow for the processing and storing of foods
in the same container.
DO NOT USE OTHER TYPES OF JARS FOR PROCESSING FOODS. Ordinary jars may break
or unscrew during processing. Do not wash any parts, including container, in an automatic
dishwasher. DO NOT fill MINI-BLEND
®
Jar above MAXIMUM FILL LINE to allow for expansion
of foods while processing. Overfilling may cause the jar to break and could result in injury.
M
ILKSHAKE BLADE
The milkshake blade is also available as an accessory, and is not normally included with your Blender.
For proper assembly and tightening instructions, see directions above and on previous page.
The milkshake blade is designed to make thick, rich milk shakes consisting primarily of ice cream
and milk. Soft fruit and crumbled cookies can also be added to shakes when using the milkshake
blade. Hard candies, nuts, and other hard foods should not be added to shakes when using the
milkshake blade. USE THE MILKSHAKE BLADE ON THE HIGHEST SPEED SETTING ONLY.
DO NOT WASH ANY PARTS, INCLUDING THE MILKSHAKE BLADE IN AN AUTOMATIC
DISHWASHER.
H
OW YOUR OSTERIZER® BLENDER WORKS
Your OSTERIZER
®
Blender is a multi-speed appliance which operates on a wide range of speeds
from very slow to very fast. This range of speeds makes food preparation easy, interesting
and also saves time because your OSTERIZER
®
Blender processes foods in seconds.
In addition, your OSTERIZER
®
Blender has two distinct methods of operation;
1
– CONTINUOUS run for blending, liquefying and fine chopping and
2 – CONTROLLED CYCLE BLENDING, used for coarse chopping pieces of food, such as
chopped vegetables, nuts or cheeses. There are several different ways of operating the
CONTROLLED CYCLE BLENDING feature but all involve turning the motor “on” and “off”
intermittently. During the “on” portion of the cycle, food is chopped and tossed away from
the blades. During the “off” portion of the cycle, the food is distributed around the blades to make
processing more uniform. IN THIS BOOK, THE CONTROLLED CYCLE BLENDING FEATURE
IS REFERRED TO AS A CYCLE.
NOTE:
A cycle consists of operating the Blender for about 2 seconds and then
allowing the blade to coast to a stop.