Taylor 162 Freezer User Manual


 
23
Models 150, 152, 162, 168 Important: Operator Checklist
051215
j 5. If your machine is air cooled, check the
condenser for an accumulation of dirt and lint.
A dirty condenser will reduce the ef ficiency and
capacity of the machine. Condensers should be
cleaned monthly with a s oft brush. Never use
screwdrivers or other metal probes to clean
between the fins. Failure to comply may result
in electrocution.
Note: For machines equipped with an air filter ,
it will be necessary to vacuum clean the filters
on a monthly schedule.
j 6. If your machine is equipped with an auxiliary
refrigeration system, check the condenser for
accumulation of dirt and lint. A dirty condenser
will reduce the refrigeration capacity of the mix
hopper. Condensers must be cleaned monthly
with a soft brush. Never use screwdrivers or
other metal probes to clean between the fins.
Failure to comply may result in electrocution.
j 7. If your m achine is water cooled, c heck the
water lines for kinks or leaks. Kinks can occur
when the machine is moved back and forth for
cleaning or maintenance purposes.
Deteriorated or cracked water lines should be
replaced only by an authorized Taylor
mechanic.
Winter Storage
If the place of business is to be closed during the winter
months, it is important to protect the freezer by
following certain precautions, particularly if the
building is subject to freezing conditions.
Disconnect the freezer from the main power source to
prevent possible electrical damage.
On water cooled freezers, disconnect the water
supply. Relieve pressure on the spring in the water
valve. Use air pressure on the outlet side to blow out
any water remaining in the condenser, and then add a
liberal amount of permanent type auto anti-freeze.
This is extremely important. Failure to follow this
procedure may cause severe and costly damage to the
refrigeration system.
Your local Taylor distributor can perform this service for
you.
Wrap detachable parts of the freezer such as the
beater assembly and freezer door, and place them in
a protected dry place. Rubber trim parts and gaskets
can be protected by wrapping them with
moisture-proof paper. All parts should be thoroughly
cleaned of dried mix or lubrication accumulations
which attract mice and other vermin.