Filter
Top Products
12
Model 390Operating Procedures
Section 7 Important: Operator Checklist
During Cleaning And Sanitizing
Cleaning and sanitizing schedules are governed by
your State or local regulatory agencies and must be
followed accordingly. The following check points
should be stressed during the cleaning and sanitizing
operations. WE RECOMMEND DAILY CLEANING
AND SANITIZING
.
ALWAYS FOLLOW LOCAL HEALTH CODES.
Troubleshooting Guide
j 1. Thoroughly clean and sanitize the machine
regularly, including complete disassembly and
brush cleaning.
j 2. Use all brushes supplied for thorough cleaning.
The brushes are specially designed to reach all
mix passageways.
j 3. Use the white bristle brush to clean the mix inlet
hole which extends from the mix hopper down
to the rear of the freezing cylinder .
j 4. Use the black bristle brush to thoroughly clean
the rear shell bearing at the rear of the freezing
cylinder. Be sure to have a generous amount of
cleaning solution on the brush.
j 5. Properly prepare the cleaning and sanitizing
solutions. Read and follow label directions
carefully. Too strong of a solution may damage
the parts and too weak of a solution will not do
an adequate job of cleaning or sanitizing.
j 6. Using a screwdriver and cloth towel, keep the
female hex drive socket and rear shell bearing
clean and free of lubricant and mix deposits.
j 7. IF LOCAL HEALTH CODES PERMIT THE
USE OF RERUN, m ake sure the r erun is stored
in a sanitized, covered stainless steel container
and used the following day. Discard all rerun
once a week.
Regular Maintenance Checks
j 1. Rotate scraper blades to allow both sides of the
knife edge to wear evenly. This will contribute to
self-sharpening and help maintain fast efficient
freezing.
j 2. Replace scraper blades that are nicked or
damaged.
j 3. Before installing the beater , be certain that
scraper blades are properly attached over the
beater pins.
j 4. Dispose of o-rings or seals that are worn, torn
or fit too loosely and replace with new ones.
j 5. Follow all lubrication procedures as outlined in
the “Assembly” instructions of this manual.
j 6. Check rear shell bearing for signs of wear
(excessive mix leakage in rear drip pan) and be
certain it is properly cleaned.
j 7. Check the condenser for accumulation of dirt
and lint. Dirty condensers will reduce the
efficiency and capacity of the machine.
Condensers should be cleaned monthly with a
soft brush. Never use screwdrivers or other
metal probes to clean between the fins.
j 8. If y our machine is water cooled, check the water
lines for kinks or leaks. Kinks can occur when
the machine is moved back and forth for
cleaning or maintenance purposes.
Deteriorated or cracked water lines should be
replaced only by an authorized Taylor
mechanic.